AUTOMET
Financiado
AUTOCONFIGURABLE METROLOGICAL MEASUREMENT SYSTEM FOR PRODUCTION LINES IN AUTOMOB...
AUTOCONFIGURABLE METROLOGICAL MEASUREMENT SYSTEM FOR PRODUCTION LINES IN AUTOMOBILE PIECES PROVIDERS
WIP has detected that the companies engaged in the manufacture of metal assemblies for automobile, providers of a lot of parts to largest car manufacturers, have several problems in the measurement and calibration of its pieces, b...
WIP has detected that the companies engaged in the manufacture of metal assemblies for automobile, providers of a lot of parts to largest car manufacturers, have several problems in the measurement and calibration of its pieces, because much of this provision is the result of processes of stamping and welding. These processes are so aggressive that deform the components, causing a dimensional uncertainty gives rise to a problem unresolved: Many of the manufactured parts are large and have complicated geometries, therefore, it is impossible to measure them in the production line. Industrial measurement systems are generally large machines (coordinate system) located in temperature controlled laboratories. Current solutions are able to measure very few parts per time unit. These laboratories are typically used inspection of a part of each lot in a production, assuming that the assembly process is effective enough to not have to measure 100 % of them. But this is not this case, WIP has since found that this rule was valid in the past, but the specifications (tolerances) that automobile companies require to their suppliers (tolerances of tenths of a millimeter in large welding pieces), are destroying this measurement model. Producing a batch of defective pieces, with erroneous measurements, may result loss of entire batch, it would have to make the batch again (large stress in production line in the factory, the viability of the line is under doubts, etc) and this would involve a high cost. Moreover, confidence would be lost with the end customer.
Therefore, due to these deficiencies in the measurement of pieces, WIP has identified a great business opportunity, especially in the field of automobile suppliers.
WIP aims to apply to the SME Instrument for the large-scale commercialization of an AUTOCONFIGURABLE METROLOGICAL MEASUREMENT SYSTEM with a FAST SET-UP in any point of the production line, focused on the EUROPEAN AUTOMOBILE SUPPLIERS MARKET mainly: AUTOMET
ver más
Duración del proyecto: 6 meses
Fecha Inicio: 2016-02-16
Fecha Fin: 2016-08-31
Fecha Fin: 2016-08-31
Línea de financiación: concedida
El organismo H2020 notifico la concesión del proyecto el día 2016-08-31
Línea de financiación objetivo
El proyecto se financió a través de la siguiente ayuda:
Presupuesto
El presupuesto total del proyecto asciende a
71K€
Líder del proyecto
WIP PROYECTOS INDUSTRIALES
Diseno de proyectos mecanicos. electricos, neumaticos y.o hidraulicos. realizacion de programas informaticos. direccion de proyectos industr...
Perfil tecnológico
TRL
6-7
236K
Perfil tecnológico
TRL
6-7
236K