NEMMO
Financiado
Next Evolution in Materials and Models for Ocean energy
NEMMO will design, model and test downscaled prototypes of larger, lighter and more durable composite blades for >2MW floating tidal turbines to reduce LCoE of tidal energy to €0.15/kWh, meeting 2025 SET-Plan targets and making it...
NEMMO will design, model and test downscaled prototypes of larger, lighter and more durable composite blades for >2MW floating tidal turbines to reduce LCoE of tidal energy to €0.15/kWh, meeting 2025 SET-Plan targets and making it competitive to competing fossil fuel sources. Novel blade designs with enhanced hydrodynamic performance due to the implementation of the different solutions, active flow control, materials and surfaces will be tested. Also, new nano-enhanced composites with properties that increase fatigue-, impact-, cavitation- and bio-fouling resistance of novel blade designs to prevent failures will be made. The project will then model, design and test the lifespan and resistance of the new composites for tidal turbine blades. This will involve: • accurate modelling of harsh hydrodynamic and environmental stresses for the development of testing and validation procedures • a new test rig for the evaluation of fatigue and cavitation on test probes and downscaled prototypes • a testing procedure including bio-fouling and marine environments evaluation in four different real scenarios • development of numerical models for the prediction of lifespan and mechanical properties as function of the materials properties, hydrodynamic loads, time and water composition • Novel tidal generator blades designs integrating active control flow, advanced surfaces and new nano-enhanced composites. The collective result of these innovations is 70% reduction in LCoE for tidal energy due to; (i) 50% CapEx reduction (lower material consumption and 25% lower cost of new composites), (ii) 2% lower FCR (increased understanding of failure and fatigue mechanisms and more durable composites with 66% higher lifespan), (iii) 40% reduction in O&M (reduced cavitation wear, bio-fouling and aging) and, (iv) 20% increase in AEP (enhanced hydrodynamic performance and higher inlet flow speeds for tidal turbine).
ver más
Duración del proyecto: 53 meses
Fecha Inicio: 2019-04-01
Fecha Fin: 2023-09-30
Fecha Fin: 2023-09-30
Línea de financiación: concedida
El organismo H2020 notifico la concesión del proyecto el día 2023-09-30
Línea de financiación objetivo
El proyecto se financió a través de la siguiente ayuda:
Presupuesto
El presupuesto total del proyecto asciende a
5M€
Líder del proyecto
FUNDACION TECNALIA RESEARCH & INNOVATION
Promoción, el desarrollo y el fomento de actividades de investigación, desarrollo e innovación
Perfil tecnológico
TRL
2-3
123M
Perfil tecnológico
TRL
2-3
123M
450.00K€ |
Participante
436.64K€ |
Participante